Mercedes-Benz

Setting the stationary heater/stationary ventilation via remote control

DANGER Risk of fatal injury due to poisonous exhaust gases

If the tailpipe is blocked or sufficient ventilation is not possible, poisonous exhaust gases such as carbon monoxide may enter the vehicle. This is the case in enclosed spaces or if the vehicle gets stuck in snow, for example.

Always switch the stationary heater off in enclosed spaces without an air extraction systems, e.g. in garages.

Keep the tailpipe and the area around the vehicle free from snow when the engine or the stationary heater are running.

Open a window on the windward side of the vehicle to ensure an adequate supply of fresh air.

WARNING Risk of fire due to hot stationary heater components

When the stationary heater is switched on, parts of the vehicle can become very hot, e.g. the exhaust system.

Flammable materials such as leaves, grass or twigs may ignite if they come into contact with:

hot parts of the exhaust system
the exhaust gas itself

When the stationary heater is switched on, make sure that:

hot vehicle parts do not come into contact with flammable materials

the exhaust gas can flow out of the tailpipe unhindered

the exhaust gas does not come into contact with flammable materials

NOTE Battery discharge caused by stationary heater or stationary ventilation operation

Operating the stationary heater or stationary ventilation drains the battery.

After heating or ventilating the vehicle twice, drive for a longer period of time.

Requirement:

The fuel tank is filled to at least reserve fuel level.

To activate immediately:

press and hold the

button.

To set the departure time:

briefly press the

button.

Press the

button repeatedly until the time to be changed appears in the display.

Press the

and

buttons simultaneously.

The symbol in the remote control display flashes.

Press the

and

buttons to set the desired departure time.

Press the

and

buttons simultaneously.

The new departure time is stored.

Up to three departure times can be stored.

To activate the departure time:

select the desired departure time and press and hold the

button.

The symbol, the departure time and, depending on the selected departure time, the letter A, B or C appear in the display.

To deactivate the departure time:

select the desired departure time and press and hold the

button.

OFF appears in the display.

To check the status of the stationary heater:

briefly press the

button.

To deactivate immediately:

press and hold the

button.