The airbag has been deployed.
The vehicle brakes sharply from a speed of more than 70 km/h to a standstill.
The hazard warning light switches off automatically when the vehicle reaches a speed exceeding 10 km/h following maximum full-stop braking.
The safety vests are located in door stowage compartments in the front door.
Safety vests can also be stored in the rear door stowage compartments.
The requirements defined by the legal standard are only fulfilled if the safety vest is the correct size and is fully closed.
it is damaged or dirt on the reflective strips can no longer be removed
the maximum number of washes is exceeded
the fluorescence of the safety vest has faded
First-aid kit (soft sided) is located in the stowage net in the right-hand side of the boot and is secured with Velcro strip .
The QR code is secured in the fuel filler flap and on the opposite side on the B-pillar. In the event of an accident, rescue services can use the QR code to quickly find the appropriate rescue card for your vehicle. The current rescue card contains the most important information about your vehicle in a compact form, e.g. the routing of the electric lines.
Further information can be obtained at Mercedes-Benz homepage - rescue card.
When charging using a battery charger without a maximum charging voltage, the battery or the on-board electronics may be damaged.
Charging the battery at very low temperatures may shorten the service life of the battery and have a negative effect on starting.
When using a battery charger without a maximum charging voltage, the battery or the vehicle electronics may be damaged.
A battery generates hydrogen gas during the charging process. If there is a short circuit or sparks start to form, there is a danger of the hydrogen gas igniting.
During the charging process and starting assistance, the battery may release an explosive gas mixture.
If the indicator/warning lamps in the instrument cluster do not light up at low temperatures, it is very likely that the discharged battery has frozen.
A discharged battery may freeze at temperatures slightly above or below freezing point.
During starting assistance or battery charging, battery gas may be released.
The service life of a battery that has been thawed may be dramatically shortened.
It is recommended that you have a thawed battery checked at a qualified specialist workshop.
Numerous or extended attempts to start the engine may damage the catalytic converter due to non-combusted fuel.
Only use undamaged jump lead/charging cables with a sufficient cross-section and insulated terminal clamps.
Non-insulated parts of the terminal clamps must not come into contact with other metal parts while the jump lead/charging cable is connected to the battery/jump-start connection point.
The jump lead/charging cable must not come into contact with any parts which may move when the engine is running.
Always make sure that neither you nor the battery is electrostatically charged.
Keep away from fire and naked flames.
Do not lean over the battery.
When charging: only use battery chargers tested and approved by Mercedes-Benz, and please read the battery charger's operating instructions before charging the battery.
Starting assistance may only be provided using batteries with a nominal voltage of 12 V.
The vehicles must not touch.
Petrol engine: Only accept starting assistance if the engine and exhaust system are cold.
When the starting assistance/charging process is complete:
If your vehicle has been with starting assistance, it may not be possible to use the electric drive for approximately 30 minutes.
You can obtain further information on starting assistance at any qualified specialist workshop.
If you manipulate or bridge a faulty fuse or if you replace it with a fuse with a higher amperage, the electric line could be overloaded.
This could result in a fire.
Incorrect fuses may cause damage to electrical components or systems.
Blown fuses must be replaced with fuses of the same rating, which you can recognise by the colour and fuse rating. The fuse ratings are listed in the fuse assignment diagram. The fuse assignment diagram is in the vehicle document wallet.
Moisture may cause damage to the electrical system or cause it to malfunction.
If the newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. a Mercedes-Benz Service Centre.
The vehicle is secured against rolling away.
All electrical consumers are switched off.
The ignition is switched off.
A flat tyre severely affects the driving characteristics as well as the steering and braking of the vehicle.
Tyres without run-flat characteristics:
Tyres with run-flat characteristics:
Vehicles with MOExtended tyres: it is possible to continue the journey for a short period of time. Make sure you observe the notes on MOExtended tyres (run-flat tyres) More.
Vehicles with a TIREFIT kit: you can repair the tyre so that it is possible to continue the journey for a short period of time. To do this, use the TIREFIT kit More.
Vehicles with Mercedes me connect: you can make a call for breakdown assistance via the overhead control panel in the case of a breakdown More.
All vehicles: change the wheel More.
Apart from some country-specific variants, vehicles are not equipped with a tyre-change tool kit. For more information on which tyre-changing tools are required and approved for performing a wheel change on your vehicle, consult a qualified specialist workshop.
jack
chock
wheel spanner
centring pin
The jack weighs approximately 3.4 kg.
The maximum load capacity of the jack can be found on the sticker affixed to the jack.
The jack is maintenance-free. If there is a malfunction, please contact a qualified specialist workshop.
The tyre-change tool kit is in a tray in the stowage space under the boot floor.
Apart from some country-specific variants, vehicles are not equipped with a tyre-change tool kit. For more information on which tyre-changing tools are required and approved for performing a wheel change on your vehicle, consult a qualified specialist workshop.
jack
chock
wheel spanner
centring pin
The jack weighs approximately 3.4 kg.
The maximum load capacity of the jack can be found on the sticker affixed to the jack.
The jack is maintenance-free. If there is a malfunction, please contact a qualified specialist workshop.
The tyre-change tool kit is located under the boot floor.
The TIREFIT kit is located under the boot floor.
Mercedes‑AMG vehicles: observe the notes in the Supplement. Otherwise, you may fail to recognise dangers.
Plug-in hybrid: observe the notes in the Supplement. Otherwise, you may fail to recognise dangers.
LK2 – 12 V/15A, 180 W, 0.8 kg
Sound power level LLA 96.0 dB (A)
The tyre inflation compressor is maintenance-free. If there is a malfunction, please contact a qualified specialist workshop.
The TIREFIT kit is located under the boot floor.
LK2 – 12 V/15A, 180 W, 0.8 kg
Sound power level LLA 96.0 dB (A)
The tyre inflation compressor is maintenance-free. If there is a malfunction, please contact a qualified specialist workshop.
The TIREFIT kit is located under the boot floor.
LK2 – 12 V/15A, 180 W, 0.8 kg
Sound power level LLA 96.0 dB (A)
The tyre inflation compressor is maintenance-free. If there is a malfunction, please contact a qualified specialist workshop.
the engine cannot be started.
the electric parking brake cannot be released or applied.
the automatic transmission cannot be shifted to position or .
If the automatic transmission cannot be shifted to position , transport the vehicle More. A towing vehicle with lifting equipment is required for vehicle transportation.
The drivetrain could be damaged when towing at excessively high speeds or over long distances.
the towing eye may become detached.
the car/trailer combination may swerve or even overturn.
If a vehicle must be tow-started or towed away, its weight must not exceed the permissible gross mass of the towing vehicle.
You can also attach the tow bar to the trailer hitch.
the ignition is switched off.
the brake system or power steering system is malfunctioning.
the energy supply or the on-board electrical system is malfunctioning.
When your vehicle is then towed away, significantly more effort may be required to steer and brake than is normally required.
If you pull away sharply, the tractive power may be too high and the vehicles could be damaged.